Search This Blog

Introduction to AutoCAD

Chapter 5 :Isometric Drawing

Get link
Facebook
X
Pinterest
Email
Other Apps

October 24, 2017

Click here to learn Isometric Drawing

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

Unknown15 September 2018 at 08:28
If I were going to learn only one CAD package, it would be AutoCAD, but you'll learn 100 times more about it using it in real life than you will in most classes.

"Art and Science test bank solutions manual Astronomy test bank solutions manual
Auditing : A business Risk Approach Louwers Beasley Rittenberg Messier Arens test bank & solutions "
ReplyDelete
Replies

Add comment

Exercise : 2D Drawing

September 18, 2017

(1.1) Draw the following diagram using AutoCAD. All units are in Inches and degrees(angles). Exercise 1.1 (1.2) Draw the following diagram using AutoCAD. All units are in Centimeters and degrees(angles). Exercise 1.2 (1.3) Draw the following diagram using AutoCAD. All units are in Centimeters. Exercise 1.3 (1.4) Draw the following diagram using AutoCAD. All units are in Meters. Exercise 1.4 (1.5) Draw the following diagram using AutoCAD. All units are in inches. Exercise 1.5 (1.6) Draw the following diagram using AutoCAD. All units are in inches. Exercise 1.6 (1.7) Create aerofoil by using below coordinates (use Spline Fit). ...

Chapter 2 : 2D Drawing basics tools

August 22, 2017

In this lesson, you will learn to use the basic drawing tools as follows 1) To draw P oints, Lines, Rectangles, Circles, Ellipses, Arcs, Polygons, Polylines and Hatch tools. 2) To use the Erase, Undo and Redo tools . 3) Draw entities using the absolute coordinate points. 4) Draw entities using the relative coordinate points. 5) Draw entities using the tracking method . POINT This command used to specify a point. You can specify a full three-dimensional location for a point. You can control the appearance of point objects by using DDPTYPE command. DDPTYPE Specifies the display style and size (Relative to screen or absolute units) of point objects. Example : In this example, you will create point object by specifying point in the absolute coordinate system. 1) Start AutoCAD 2) On the Welcome screen, click Start Drawing > Templates > acadISO-Named PlotStyles.dwt . This starts a new drawing using the ISO template. 3...

Chapter 1 : AutoCAD user interface